For compliance with this document, both the definitive requirements and those required in Clause 4 are meant to be satisfied.ġ All pressures are in mbar gauge unless otherwise stated 1 bar = 0,1 MPa. In addition to the definitive requirements, this document also states that the items detailed in Annex A have to be documented. This document is applicable to storage tanks where, irrespective of the material strength used, the maximum allowable stress does not exceed 260 N/mm2.

first circumferential joint in a pipe not having a flange connection. first threaded joint on the pipe or coupling outside of the tank shell, roof or bottom and face of the first flange in a bolted flange connection The limits of application of this document terminate at the following locations: However, for construction, fabrication, welding, inspection and testing, the relevant sections of EN 14015 is applicable. In these cases, EN 13445‐3 is applicable.

When designing a tank above 60 mbar internal pressure and negative internal pressure of lower than 6 mbar up to the limits of the PED, the formula explained in EN 14015 would not be valid. b) design metal temperature not lower than ‐40 ☌ and not higher than +300 ☌ (see 5.2.2) Ĭ) maximum design liquid level not higher than the top of the cylindrical shell. This document applies to storage tanks with the following characteristics:Ī) design pressure less than 60 mbar1 and design internal negative pressure not lower than 6,0 mbar (see 5.1 for pressure limitations. It does not apply to 'lift‐type' gas holders. This document applies to closed‐top tanks, with and without internal floating roofs (see Annex C) and open‐top tanks, with and without floating roofs (see Annexes D and E). When calculating thicknesses of tank components according to the relevant EuroCodes, it is not allowed to reduce the plate thicknesses and other dimensions below the values that have been established whilst using the theories as specified in EN 14015. BS EN 14015:2004 This standard BS EN 14015:2004 Specification for the design and manufacture of site built, vertical, cylindrical, flat-bottomed, above ground, welded, steel tanks for the storage of liquids at ambient temperature and above is classified in these ICS categories: 23.020. If agreed between purchaser and supplier, the tank can also fulfill the requirements of Eurocodes. These aspects are covered in detail in other Codes of Practice.

This document is concerned with the structural integrity of the basic tank structure and does not provide requirements for considering process design, operational issues, in‐service inspection, maintenance or repair. This document does not apply to tanks where the product is refrigerated to maintain it as a liquid at atmospheric pressure (see EN 14620 all parts). This document specifies the requirements for the materials, design, fabrication, erection, testing and inspection of site built, vertical, cylindrical, flat bottomed, above ground, welded, steel tanks for the storage of liquids at ambient temperatures and above, and the technical agreements that need to be reached (see Annex A). Metallic tanks for the storage of liquids Current stage: 30.98 Project deleted Sep 30, 2022

En 14015 calculation